Midland G9 User Manual

12 | Midland G9/G9E Plus instruction guide
Operations
Turning on/off
To turn on the transceiver, turn the VOLUME knob clockwise until you
hear it clicks. To turn off the transceiver, turn the knob counter-clockwise.
Selecting the PMR466 or LDP band
(only for the dual band version)
Midland G9 Plus (Dual band) is pre-set at factory on the PMR446 band.
To switch to the LPD band, keep pressed the MENU button until the LPD
shows channel ‘1’.
To return to the PMR446 band, keep pressed the MENU button again,
until the LCD shows ‘P1’.
This procedure disables the “EMG” function; therefore if you change the
frequency band, remember to activate the Emergency function again
(see paragraph “Emergency function”).
Channel selection
Press the MENU button. The number of the channel will start flashing on
the display.
Press the scroll buttons ▲▼ till you select the desired channel.
Press the PTT button to confirm, or wait for 5 seconds.
According to the version you bought, you can choose amongst the fol-
lowing channels:
• Dual band version: PMR446 from P1 to P8 and from 9p to 24p (pre-
set) / LPD from 1 to 69.
• E version (PMR446 only): from P1 to P8 and from 9p to 24p (pre-set)
Channel P8 has been set at factory for the “Emergency” function; we sug-
gest that you do not use it for general communications!
Displaying the channel/sub audio tone
To momentarily display the PMR446 channel and the subadio tone used
in the pre-set channels, go to the desired channel (from 9p to 24p) and
keep pressed the ▼ for 3 seconds.

Midland G9 Specifications

General

VOX	Yes
Water Resistance	IPX4
Display	LCD
Frequency Range	446.00625 - 446.09375 MHz
Channels	8
Output Power	500 mW ERP (PMR446); 10 mW (LPD433)
Weight	120 g (without batteries)