Midland G9 - Automatic Out-Of-Range; Display Illumination; Power Save

Midland G9/G9E Plus instruction guide | 21
After this pause, the Dual Watch starts again.
This function can be activated only if the “Emergency” feature is disabled.
Automatic Out-of-Range
By setting this mode a pair of G9 Plus is transmitting every 30 seconds a
data control code. As soon as the contact between both units is getting
lost and one radio doesn’t receive this data control code twice consecuti-
vely, the icon OUT starts flashing in the display and you will hear a beep
tone.
This function can be activated only if the “Emergency” feature is disabled.
Activating – Deactivating
1. Press MENU till the display shows “OUT” and “Or of”, select “Or on”
(activated) with the ▲▼ buttons.
2. Switch off both radios.
3. Turn them on at the same time.
To disable this function:
1. Push MENU till “OUT” and “Or on” are displayed;
2. Select “Or of” (disabled) with the ▲▼ buttons.
3. Confirm your selection by pushing PTT or wait for 5 seconds.
Display illumination
If there is insufficient light to read the display, press briefly EMG and the
display illumination will activate for about 5 seconds. Every time the
MENU is pressed, the display will automatically light up.
Power save
The battery power saving feature enables a reduction in the consumption
of up to 50%; power saving comes on automatically when the transceiver
does not receive any signal for more than 7 seconds. When the batteries
are discharged, the icon
CALL
MENU
EMG
15
24
23
22
21
20
19
18
17
16
3
2
1
14
13
12
10
9
11
8
7
6
5
4
appears on the display: replace the batteries
or recharge the battery pack.
The power save is active only if the Emergency function is disabled.