Midland G9 - Vibra-Call Function; CALL Feature; ROGER BEEP (End Transmission Tone); Keypad Beep

18 | Midland G9/G9E Plus instruction guide
Vibra-Call function
Midland G9 Plus is equipped with the “Vibra-Call” feature, which provi-
des a silent alert for incoming calls.
1. To activate this feature, press the MENU button until the display
shows
CALL
MENU
EMG
15
24
23
22
21
20
19
18
17
16
3
2
1
14
13
12
10
9
11
8
7
6
5
4
.
2. Use the ▲▼ buttons to disable or enable this feature (on: enables,
oF:disables).
3. Push PTT [11] to confirm or wait for 5 seconds.
CALL feature
Midland G9 Plus can send 5 different CALL tones. To send this audio si-
gnal to other users, press the CALL/
CALL
MENU
EMG
15
24
23
22
21
20
19
18
17
16
3
2
1
14
13
12
10
9
11
8
7
6
5
4
key.
To select the CALL tones:
1. Press MENU, until the display shows “CA” and the active tone code.
2. By pushing ▲▼ you will hear the 5 pre-set melodies.
3. Confirm by pressing PTT or wait for 5 seconds.
ROGER BEEP (End transmission tone)
When the PTT button is released, the radio will beep to confirm to other
users that your transmission has finished.
In the Midland G9 Plus this function is factory disabled.
To activate it:
1. Press the MENU button until the display shows “rb of”;
2. Using the scroll buttons ▲▼ select “on” and “rb on” will be displa-
yed;
3. To confirm the roger beep activation, press PTT or wait for 5 secon-
ds.
Keypad Beep
Everytime a button is pressed, you will hear a beep.
To disable the beeps, follow this procedure:
1. Press MENU, till the display shows “bP on”.
2. Push ▲▼ till “bP of” is displayed.
3. Confirm your selection by pushing PTT or wait for 5 seconds.
In this way, all beeps and tones are disabled.
To enable the keypad beep, repeat this procedure and select “bP on”