13
display. Press and release the SELECT button. The alarm hour
setting will begin flashing. (Note and adjust A.M./P.M. indicator
located to left of the flashing alarm hour setting.) Press and
release the “UP” arrow to adjust the alarm hour setting. Press and
release the “RIGHT” arrow to choose setting alarm minutes.
Press and release the “UP” arrow to adjust the alarm minute
setting. Press the “SELECT” button to store the Alarm settings.
Choose type of alarm. Press and Release “MENU”. Use “UP”
arrow to choose radio or sound for clock alarm. (The
icons are located below the clock display.) Press “SELECT” to
store the type of alarm setting.
To activate the alarm, set the “ALARM OFF/ON” switch to the
“ON” position. The clock face icon will appear. To cancel
the alarm when sounding, press a button other than “SNOOZE”.
The “SNOOZE” button on the top of the WR-300 is for
advancing the alarm time by 9 minutes each time the alarm
sounds. The “SNZ” icon will be displayed.
(Turn alarm off with the ”ALARM OFF/ON” switch on side of
unit.)
5. PROGRAM THE WEATHER CHANNEL FOR YOUR
AREA. After you select the weather channel in your area, your
Weather Monitor will receive all alerts issued by the National
Weather Service. Program your Weather Monitor with the
weather channel in your area as follows:
To Next Page
Loading...
