Midtronics GRX-3080 JLR EU

GRX-3080 JLR EU STANDALONE
Midtronics B.V. Hoofdveste 6 Houten NL
www.midtronics.com
26
Chapter 8: Power Supply
The Power Supply function should be used when ever the
vehicle comes in to the workshop for regular maintenance
or ECU re-ashing.
Re-ashing an ECU can take up to several hours and during
that period a lot of current can be drawn from the battery. To
support the battery during this process you use the power
supply function.
Always make sure that when you work on the vehicle the
charger is switched in to the Power Supply function so that
you ensure that when the work is done the battery’s state of
charge is maintained at a healthy level.
From the MAIN Menu, highlight the POWER SUPPLY icon
and press the SELECT key. The GRX-3080 JLR will immedi-
ately begin to supply power.
Settings in UTILITY menu for Power Supply
Go to the UTILITY menu and select CONFIG CHARGER, use
the UP () or DOWN () ARROW to select PS VOLTAGE.
Set the voltage to your requirement.
Chapter 8: Power Supply