Midtronics GRX-3080 JLR EU - Chapter 10: Print; View Menu; View Test; Statistics; Clear Counters

GRX-3080 JLR EU STANDALONE
Midtronics B.V. Hoofdveste 6 Houten NL
www.midtronics.com
28
Chapter 10: Print / View menu
The Print/View Menu enables you to view and print the re-
sults of the charge cycles before you perform another cycle
and overwrite the results in memory.
View test
VIEW TEST gives you the option of viewing and printing the
last results. To print the results, select the PRINT soft key.
To return to the MAIN Menu, press the END key.
Statistics
This gives you the option of viewing the statistical data
collected for all the charge cycles in various ways or to reset
the counters.
Use the UP () or DOWN () ARROW key to scroll through
the data.
The STATISTICS show the total number of completed tests
by battery decisions since the last time the totals were reset
to 0.
STATISTICS
GOOD BATTERY 0
REPLACE BATTERY 0
BADCELL-REPLACE 3
CHARGING ABORTED 0
1 OF 5
STATISTICS
CLEAR COUNTERS
5 OF 5
Press NEXT to make the selection and go into average test
information or the clear counters functionality. Press BACK
to return to the MAIN MENU.
Clear counters
This allows you to reset the counters completely.
STATISTICS
Press the YES soft key to clear the counters or the NO soft
key to cancel.
Problems with the Internal Printer
The internal printer will not print
• Make sure the Battery Diagnostic Station is connected
to AC power and the POWER switch is pressed to the
ON position.
• Verify that the paper is properly installed.
Changing the Paper in the Internal Printer
The internal printer is shipped with a roll of thermal printing
paper installed in the paper compartment. The roll size is
2¼inches wide by 1
7
/
8
inch in diameter. Replacement rolls
are available at most oce supply stores.
The Battery Diagnostic Station uses only thermal
printing paper.
To replace the paper roll:
1. Unlock the printer door by gently lifting the latch on the
printer.
2. Lift the printer door and remove the spent roll.
3. Place a new roll of paper in the compartment. The pa-
per feeds from the bottom of the roll.
4. Pull the paper forward so that it extends past the ser-
rated edge of the paper slot.
5. Close the door and make sure the lever locks securely.
For a clean tear, pull the paper along the serrated edge.
Do not pull the paper straight out of the printer.
Chapter 10: Print / View menu