Checking the programmed water
hardness
^
Turn off the dishwasher.
^
Turn the program selector to “Stop”.
^
Hold the “Top Solo” button in and at
the same time turn the dishwasher
on with the “On/Off” button. With in
2 seconds release the “Top Solo”
button.
The “Salt” indicator flashes.
Note:
If any other indicators light or flash the
process must be repeated.
Except:
If the “Rinse aid” indicator lights rinse
aid was never added or needs to be re-
filled.
^ Turn the program selector past “Nor-
mal 55 °C/130 °F” to “Energy Saver”.
The “Top Solo” indicator will light when
the programmed water hardness set-
ting is reached. The water hardness
level corresponds to the program selec
-
tor position (see the table “Pro
-
gramming and setting the water hard
-
ness level”).
^
Turn the program selector to “Stop”.
^
Turn off the dishwasher.
Before using for the first time
16
To Next Page
Loading...
