Program chart
Program When to use Detergent
chlorine
free
1)
containing
chlorine
2)
Compart
-
ment
II
(Wash
cycle)
Compart
-
ment
I
(Pre-wash)
Compart
-
ment
II
(Wash
cycle)
Normal
3)
55 °C/130 °F
for normal everyday loads 100 % 20 % 80 %
Sani Wash as Normal 55 °C/130 °F
but with longer wash time for heavily soiled
loads, also suitable for chlorine free deter
-
gents
100 % 20 % 80 %
Normal
65 °C/150 °F
as Normal 55 °C/130 °F,
but at a higher temperature for stubborn
dried on food
100% 20 % 80 %
Light Wash
55 °C/130 °F
for normal everyday loads,
particularly suitable for chlorine free deter-
gents
100 % 100 %
Economy
55 °C/115 °F
for normal everyday loads,
particularly energy saving program
100 % 100 %
Special Program
China & Crystal
45 °C/115 °F
“Gentle program”, for lightly soiled and
heat sensitive tableware.
50 % 50 %
Rinse & Hold For rinsing dishes when a complete cycle is
not needed.
Energy Saver for lightly to normally soiled dishes only
select Energy Saver if the dishwasher is
connected to a hot water supply (min. tem
-
perature 45 °C/115 °F).
- see “Choosing a program”
100 % 20 % 80 %
The dispensing method will depend on the type of detergent being used.
1) Use this ratio for:
– detergent which is chlorine and phosphate free
– detergent which is chlorine free but contains phosphates
In this instance the whole amount is placed in compartment II.
2) Use this ratio for:
– powder detergent which contains chlorine and phosphates.
Divide the total amount, as shown, between compartment I and compartment II.
When washing a full load in the Normal program, the Sani Wash program, the Light Wash program or
the Economy program at least 1 ½ tablespoons (25 ml) of detergent are required.
Program chart
56
To Next Page
Loading...
