Correcting minor faults
. . . There has been a power failure,
and instead of the time of day "0
••
00"
and "AUTO" flash in the display
All pre-set times are deleted as a result
of the power failure.
Enter the time of day again, and any
other pre-set data.
. . . “0
••
00" appears when the audible
tone is switched off
This is not a fault.
The time of day will shortly reappear in
the display field.
. . . “AUTO” flashed in the timer dis-
play
This might signal a data entry mistake,
– for example entering conflicting
times.
– if the time of day is changed while a
start and finish time have been pre-
set.
– when the acoustic tone is switched
off by pressing the “g ” and “)”
buttons.
52
To Next Page
Loading...
