To cancel the residual moisture
evaporation process
After the appliance has been
switched on, the prompt to evaporate
residual moisture will appear in the
display. Touch the sensor next to
"Cancel". You will only be able to run
functions and Automatic programmes
without Moisture plus.
If you select "Moisture plus" or one
of the Automatic programmes with
Moisture plus, the prompt to evaporate
residual moisture will appear immedi
-
ately.
If you do not want to start the residual
moisture evaporation process, you will
need to press the Cancel sensor for at
least 3 seconds.
You can now start the cooking
programme.
,
Do not cancel the prompt for
residual moisture evaporation too
often, as this might cause the steam
injection system to overflow when
taking in more water.
Descaling
The oven will need to be descaled
depending on the number of cooking
programmes using Moisture plus which
have been run and the amount of water
taken into the oven for these. This will
be indicated in the display.
The steam injection system should be
descaled regularly. How often this
needs to be done will depend on the
water hardness level in your area.
You can start the descaling process at
any time by selecting "Descale" in the
main menu.
If you do not carry out the descaling
process when the prompt to descale
the oven appears, you will only be able
to run functions and Automatic
programmes without Moisture plus.
See "Cleaning and care" for more
information about descaling.
Moisture plus
45
To Next Page
Loading...
Need help?
General
