Problem solving guide
80
Problem Cause and remedy
White residue is visible
on crockery and cutlery,
clouding occurs on
glassware; film can be
wiped off.
The rinse aid dosage is set too low.
Increase the dosage (see "Settings menu, Rinse
aid").
There is no salt in the salt reservoir.
Fill the salt reservoir (see "Before using for the first
time, Dishwasher salt").
An unsuitable combination product has been used.
Change your detergent. Use a standard liquid, tab-
let or powder detergent.
The water softener is programmed to too low a water
hardness level.
Programme the water softener to a higher water
hardness level (see "Settings menu, Water hard-
ness").
There are rust stains on
cutlery.
The affected items are not corrosion resistant.
There is no remedy.
Purchase cutlery which is dishwasher-proof.
A programme was not run after dishwasher salt was
added. Traces of salt have got into the wash cycle.
Always run the QuickPowerWash programme with
the Shortprogramme option selected and without
any crockery in the dishwasher after adding dish-
washer salt.
To Next Page
Loading...
