Problem solving guide
73
Water inlet fault
Problem Cause and remedy
All in-operation indicat-
ors are flashing quickly.
The warning buzzer is
sounding.
One of the following
faults is shown in the
display:
Water inlet fault. Please
open the stopcock
The stopcock is closed.
Open the stopcock fully.
Water inlet fault Before rectifying the problem:
Switch the dishwasher off using the sensor.
The water intake is restricted.
Open the stopcock fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than 50
kPa (0.5 bar).
Seek professional advice.
The following message
appears in the display
during the SolarSave pro-
gramme:
Water in. temp. too low
The intake water has not reached the required tem-
perature of 45°C (see "Plumbing, Connection to the
water supply").
Start the programme again.
If the fault message appears again, select a differ-
ent programme.
To Next Page
Loading...
Need help?
General
