Plumbing
90
– The inlet hose is approx. 1.5m long.
A 1.5m long flexible metal extension
hose (pressure tested to 14000
kPa/140 bar) is available as an op-
tional accessory, if required.
– A stopcock with a 3/4" male thread
must be provided on site.
– This appliance is constructed to
comply with IEC/EN/DIN 61770 //
VDE 0700 Section 600, and may be
connected to a suitable supply
without an extra non-return valve if
national regulations permit.
– The water pressure (flow pressure at
the take-off point) must be between
50 and 1000kPa (0.5 and 10bar). If
the water pressure is lower than this,
the fault message Water intake will ap-
pear in the display (see "Problem
solving guide"). If the water pressure
is too high, a pressure reducer valve
must be fitted.
After connecting the dishwasher to
the water supply, check that all
plumbing connections are watertight.
To avoid any damage to the ap-
pliance, the dishwasher must only be
operated when it is connected to a
fully vented plumbing system.
The inlet hose must not be
shortened or damaged in any way as
it contains electrical components
(see illustration).
To Next Page
Loading...
Need help?
General
