Switching on
When using the gas hob an extractor hood or a ventilation
device must be used.
^
The control for the burner required must be pressed in and
turned anti-clockwise to the largest flame symbol to switch
on. The ignitor clicks, and the gas is lit.
When a control is operated, a spark is produced on all
cooking zones. This is not a fault.
If the burner does not ignite, turn the control to "ß". Ensure
that the room is well ventilated, and wait at least 1 minute
before trying again.
If the burner does not ignite the second time, turn the control
to "ß", and see "Problem solving guide".
When switching on, re-ignition sometimes occurs (1-2 clicks)
if the flame on the ignition safety device has gone out briefly,
or if the thermal element is not hot enough, e.g. following a
gust of air.
Operation
20
To Next Page
Loading...
