Miele PG 8056 - Fault Code Resolution

Frequently asked questions
100
Problem Possible cause and solution
Fault 412-414 Water inlet fault.
One of these numbers will appear in the display if the flow
pressure is too high and the program will be cancelled.
 The flow pressure at the water intake point is too high
(see "Technical data"). Contact Miele Service for advice.
Fault 492, 504, 541 Fault during program start. There may still be water in the
wash cabinet.
 Clean the filter combination (see "Cleaning and care").
 Clean the non-return valve (see "Frequently asked
questions").
Fault 550 The Waterproof system was activated.
 Close the water supply valve.
 Contact Miele Service.
Check drainage The water outlet is restricted. There might be water in the
wash cabinet.
 Clean the filter combination (see "Cleaning and care").
 Clean the drain pump (see "Frequently asked
questions").
 Clean the non-return valve (see "Frequently asked
questions").
 Remove any kink or loop in the drain hose.
Fault XXX
(XXX stands for a number)
A malfunction may have occurred.
After waiting 10seconds:
 Turn the dishwasher back on.
 Select the desired program.
 Press the Start/Stop button.
If the fault message is displayed again, there has been a
malfunction.
 Contact Miele Service.