Operation
52
Program end
When a program ends normally, the LED for the Start/Stopbutton will
go out. The message Program finishedwill appear in the bottom line of
the display.
Normal plus
Temperature
Program finished
55 °C
In addition, a buzzer will also sound for approx. 3 seconds (factory
default setting). To adjust the buzzer volume, see "Settings, Volume".
If the Switch-off function is enabled, the dishwasher switches itself
off after a short period of time.
Press the button to switch the dishwasher on again.
Turning off the dishwasher
Press the button until the button's LED goes out.
Unloading the dishwasher
Dishes tend to break and chip more easily when they are hot. Allow
the dishes to cool until they are cool enough to handle before
unloading them.
The dishes will cool much faster if you open the door when the
program has ended.
First unload the lower basket, then the upper basket. This will prevent
water drops from the upper basket falling onto the dishes in the lower
basket.
To Next Page
Loading...
