Miele PG 8056 - Setting the Water Hardness Level

Filling the salt container
27
Setting the water hardness level
The water softener can be set to between 0 and 73 gpg (0 - 70°dH
German scale).
 Select the Additional settings menu.
 Select Water hardness and confirm your choice with theOKbutton.
Water hardness
19
(0 - 70 °dH)
°dH
The factory default setting for the water softener is a hardness of 20
gpg (19°dH German scale).
Please observe the table below when setting the hardness level.
If the water hardness fluctuates, e.g. between 8 and 18 gpg (8 and 17
°dH German scale), always be sure to set the dishwasher to the
higher value, 18 gpg (17°dH German scale) in this example.
 Use the arrow buttons  (higher) and  (lower) to set the required
water hardness level, and confirm your entry with the OKbutton.