Operation
48
LEDs on the
keypad
Light-emitting diodes that indicate the status of the dishwasher are
integrated in the keypad.
Except for the Start/Stop button, which has a green LED during
normal operation, all other LEDs light up yellow.
In the event of a fault the Start/Stop button flashes red.
Button LED Status
(On/Off)
Button
ON The dishwasher is on.
FLASHES The dishwasher has entered standby
mode after the preset time.
OFF The dishwasher is off.
,
and
button
s (program
shortcut
buttons)
ON The lit program has been selected. At
the end of the program, the LED will
remain lit until a different program is
selected.
OFF The program is not selected, or program
settings are being configured.
button
(additional
programs)
ON A program was selected from the
program list. At the end of the program,
the LED will remain lit until a different
program is selected.
OFF No program has been selected from the
list, or program settings are being
configured.
Start/Stop
button
ON A program is running.
FLASHES
GREEN
A program has been selected, but has
not yet started.
FLASHES
RED
A fault has occurred.
OFF A program has finished.
To Next Page
Loading...
