With the help of the following notes, minor faults in the performance of the machi
-
ne, some of which may result from incorrect operation, can be put right without
contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a suitab
-
ly qualified person in strict accordance with current local and national safety re
-
gulations. Repairs and other work by unqualified persons could be dangerous.
The manufacturer cannot be held liable for unauthorised work.
The programme does not start
Problem Possible cause Remedy
The display remains
dark, and the Start/
Stop button indicator
light does not come
on.
There is no power to
the machine.
Check whether
– the mains plug is plugged
in and switched on.
– the fuse or circuit breaker
has tripped.
You are asked to enter
a code.
Access via a code has
been activated.
Enter the code and confirm
the entry. Deactivate the code
if you do not wish this messa-
ge to appear in the display
the next time the machine is
switched on.
The display is dark. The display has swit
-
ched off automatically
to save energy (Stand
-
by mode).
Press a button. Standby co
-
mes to an end.
Problem solving guide
33
To Next Page
Loading...
Need help?
General
