Fault messages in the display
Problem Possible cause Remedy A
! lights up in the dis
-
play and
Drain fault
flashes.
–
The water outlet is
blocked or restric
-
ted.
–
The drain hose has
been fixed too high.
–
Clean the drain filter and
the drain pump.
–
The maximum delivery
head is 1 m.
! lights up in the dis
-
play and
Water inlet
fault
flashes.
–
The water inlet is
blocked or restric
-
ted.
Check whether
–
the stopcock is opened
properly.
– the inlet hose is kinked.
! lights up in the dis-
play and
Waterproof
fault
flashes.
The water protection
system has reacted.
Call the Service Department.
! lights up in the dis-
play and
Technical
fault
flashes.
There is a fault. Start the programme again.
If the fault message appears
again, contact the Service
Department.
Anti-crease
Chk detergent
flashes in the display.
Excessive foam has
built up during was
-
hing.
Use less detergent next time
and follow the manufacturer's
instructions on dosage given
on the packaging.
A To switch off the fault message: Switch the machine off with
I-On/0-Off
button.
Problem solving guide
34
To Next Page
Loading...
