Problem Possible cause Remedy
The programme does
not start and the display
is dark.
No obvious cause.
–
Is the dryer switched
on?
–
Is the door closed
properly?
–
Has the fuse or circuit
breaker tripped?
When the power comes
back on after a power
cut, confirm with OK and
start the programme
again.
The display is in a
different language.
A different language has
been selected in "Settings
J" "Language J".
Set the language you
want. The flag symbol
will guide you.
The indicator lamp for
the Start button is
flashing when a
programme is being
selected.
This is not a fault.
The flashing indicates
that a programme can be
started.
Once the programme has
started, the Start button
stops flashing and lights
up constantly.
The display is dark and
the light ring around the
programme selector is
not lit up.
The Start button light
flashes slowly.
The display has switched
off automatically to save
energy (Standby mode).
The same applies to the
programme selector.
The display and
programme selector are
lit up after pressing a
button or turning the
programme selector.
The programme selector
light goes out when the
Settings menu has been
selected.
The programme selector
light comes on when a
programme is selected.
If the problem persists,
there is a fault.
Contact the Miele Service
Department.
Problem solving guide
38
To Next Page
Loading...
