Changing the lamp
Disconnect the dryer from the mains
electricity supply.
A Open the door.
The lighting is at the top of the door
opening on the right-hand side.
B Remove the screw.
C Lower the cover.
D Replace the lamp.
The temperature resistant lamp should
only be ordered from the Miele Spare
Parts Department.
,
The lamp specification and
maximum wattage is stated on the
data plate and on the lamp cover.
E Raise the cover again.
F Replace the screw.
,
Ensure that it is fitted into
position securely, as any moisture
could cause a short circuit.
Problem solving guide
39
To Next Page
Loading...
