Clean out airways
The electronic unit in the dryer
detects the degree of a blockage
caused by fluff or detergent residues
in the fluff filter or ducting, and the
following prompt comes up in the
display: Clean out airways. You can
decide at what level of fluff this
message should appear.
You will have an idea of how often this
should be done after a few drying
programmes.
–
Off
Clean out airways does not appear.
In cases of a very severe blockage in
the ducting, the programme is
cancelled and the message Clean
out airways comes up regardless of
this option.
– Heavy
Clean out airways only appears
when there is a heavy build-up of
fluff
–
Normal
(Factory default setting)
–
Light
Clean out airways appears when
there is only a small build-up of fluff.
Delay start
You can set a later start time using
Delay start (see "Delay start").
You can decide how this time is
displayed.
–
Programme end
The finish time for the programme is
selected.
–
Programme start
The start time for the programme is
selected.
– Time until start
The time until the start of the
programme is selected in
minutes/hours.
– Off
(factory default)
By pressing the + button, the time
remaining and the finish time for the
programme is displayed.
Settings menu
60
To Next Page
Loading...
