~
When installing multiple dryers to
one collective exhaust duct, a
non-return flap per dryer must be
installed directly to the collective duct.
Otherwise the dryers could be
damaged and the electrical safety
affected.
~
The installation of this unit in non
stationary locations (e.g. ships) must be
performed by a qualified installer or
service agency, in strict accordance
with national and local safety
regulations and standards.
~
Do not install the machine in rooms
where temperatures below freezing
may occur.
~
If there is any doubt concerning
installation, contact Miele’s Technical
Service Department.
SAVE THESE
INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
35
To Next Page
Loading...
