Cleaning the airways
The lint filters must be cleaned after
every drying cycle. Additionally the
indicator "Clean out airways" lights
once a certain level of lint is
collected. The user can decide at
which level of lint collection the
indicator should come on.
off
"Clean out airways" does not light up
heavy
"Clean out airways" shows only when
large amount of lint is collected.
normal
Factory default
light
"Clean out airways" shows even when a
small amount of lint is collected.
Cleaning the lint filters
The display "Clean filter" reminds the
user to clean the lint filter. The user
can decide after how many
operating hours this reminder should
show.
The setting depends on the amount of
lint. Adjust the interval depending on
the use of the dryer.
Factory default: after 20 hours.
Display the residual moisture
as a percentage
In addition to the drying levels, the
residual moisture as a % can be
displayed in the program cycle.
Factory default: without percent
indication
Cool air free
If the dryer is used with a coin
mechanism, the program "Cool air"
can be provided free of charge.
free (factory default)
Settings - Supervisor level
60
To Next Page
Loading...
