Blowing out
Blower connection socket
(optional accessory for S 758)
The blower connection socket can be
used to connect the suction hose to the
"blower" outlet of the vacuum cleaner,
e.g. for dusting off multi-layered
radiators and blowing dust out of
inaccessible corners so that it can be
vacuumed up. It can also be used to
"blow out" the suction hose if it should
ever become blocked.
^ Press the release button for the dust
compartment lid and raise up the lid
up as far as it will go.
^ Take out the exhaust filter or the filter
grille if this has been fitted and
replace with the blower connection
socket.
^ Close the dust compartment lid.
^
Now open the accessories
compartment and insert the elbow of
the suction tube into the blower
connection socket.
The blower connection socket is easy
to remove by unclipping it and lifting it
up at an angle and then pulling it firmly
out towards you. Remember to refit the
exhaust filter or the filter grille.
Operation
22
To Next Page
Loading...
