When to change the thread
lifters
The thread lifters on the suction inlet to
the floorhead and upholstery nozzle
can be replaced.
Check them from time to time and
replace them if the pile has worn down.
To replace the thread lifters
^ Use a knife or similar object to
remove them from the slots.
^ Fit the new thread lifters
If threads or hair have wound round
the bearing on the floorhead roller
a Use a coin to release the roller pin
(bayonet connection) and pull out
the pin.
b Take out the roller.
Remove all threads and hair etc, then
replace the individual parts in the
correct order.
Spare parts are available from your
Miele dealer or from the Miele Spare
Parts Department.
Maintenance and care
31
To Next Page
Loading...
