Once a programme has started
- changing the programme
You cannot change to another
programme once a programme has
started (this prevents unintentional
alterations).
If an attempt is made to change a
selection: Option not possible will
appear in the display.
It is still possible to select or deselect
the Anti-crease and Buzzer Extra
options.
You will need to cancel the current
programme before you can select a
new one.
- cancelling the programme and then
selecting a different programme
^ Press the Start/Stop button.
Cancel programme will appear in the
display.
^
Press the OK button.
The items will be cooled down,
depending on the temperature
reached and how long they have
been dried for.
If you press the Start/Stop button
during the cooling down phase and
confirm by pressing the OK button,
Finished will appear in the display.
^
Press the Door button.
^
Close the door.
^
Select another programme and start
it.
Note: A programme can also be
cancelled by turning the programme
selector to Stop.
- cancelling the programme and then
removing the laundry
^
Proceed as described below in
"Adding or removing laundry after a
programme has started".
^
Switch the dryer off after closing the
door.
Altering Delay start
^ See "Delay start".
Adding or removing laundry
after a programme has started
^ Press the Door button.
^ Open the door.
^ Add or remove items as required.
^ Close the door.
^
Press the Start/Stop button.
Time remaining
The time left shown in the display may
now vary from the actual drying time.
Changing the programme sequence
31
To Next Page
Loading...
