The following will appear in the display:
0 Lock code activated
Once the tumble dryer is switched off, it
can only be used again if the lock code
is entered.
To use the dryer when the lock code
is activated
When the tumble dryer is switched on
again, the display will request the code.
^ Enter code 250 as described above
and confirm the entry.
The dryer is now unlocked and ready
for use.
To deactivate the code
Proceed as for activating the code.
Buzzer
The buzzer has two volumes.
Normal (Factory default setting)
The buzzer sounds at the end of a
programme.
Loud
The buzzer sounds at maximum volume
at the end of a programme.
Keypad tone
An audible tone sounds each time a
button is pressed.
Factory default: Off.
Contrast
Brightness
There are ten different display
contrast and display brightness
settings.
The bars
O O O O O O O O O O show you the
level which is set.
Factory default: a medium setting.
If you make an alteration it will appear
in the display immediately.
Settings menu
60
To Next Page
Loading...
Need help?
General