Problem Possible cause Remedy
There are humming
noises.
The compressor is
operating.
None. These noises are quite
normal and do not indicate a
fault.
The display is dark.
The programme
selector is not lit up.
The Start/Stop button
light flashes slowly.
The display has
switched off
automatically to save
energy (Standby mode).
The light of the
programme selector
goes out when selecting
Menu J.
The display will light up
when one of the buttons is
pressed.
A programme cannot
be started.
There is no immediate
cause.
–
Is the dryer switched on?
– Is the mains plug plugged
in?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
Power cut When power is restored to the dryer after a power cut,
the programme will continue as long as the cooling
down phase had not been reached.
The display is in a
different language.
A different language has
been selected.
Set the language you want.
The flag symbol J will guide
you.
The Start/Stop button
light flashes when a
programme is being
selected.
This is not a fault.
The flashing indicates
that a programme can
be started.
After the programme has
started, the flashing will
change to a constant light.
The interior drum
lighting does not
come on.
The lighting switches off
automatically (to save
energy).
–
Switch the dryer off and
then on again.
–
If the lamp needs to be
replaced, follow the
instructions in "Changing
the lamp" at the end of this
section.
Problem solving guide
44
To Next Page
Loading...
Need help?
General