Problem solving guide
66
Problem Cause and remedy
Information
Clean out airways
lights up at the end of a
pr
ogramme
There is a build-up of fluff in the airways.
Clea
n the fluff filters.
Clea
n the plinth filter.
See "Cleaning and care".
To switch off the message:
Confirm OK.
Clean out airways
Clean the fluff filter and
check the airways.
li
ghts up after a pro‐
gramme has been can‐
celled
An excessive amount of fluff has built up.
Clea
n the fluff filters.
Clea
n the plinth filter.
Clean the airways:
Clea
n the area underneath the plinth filter.
Clea
n the heat exchanger.
To switch off the messages:
Switch the dr
yer off and back on again.
Empty container
Empty the container or
check the drain hose.
l
ights up after a pro‐
gramme has been can‐
celled
The condensed water container is full or there is kink
in the dr
ain hose.
Empty the contai
ner.
C
heck the drain hose.
To switch off the message:
Open and close
the door while the dryer is switch‐
ed on or switch the dryer off and back on again.
Information
Fill condensate container
This is to remind you that water is taken from the
c
ondensed water container when the Steam smooth‐
ing programme is being used.
The condensed water container must be filled with
wat
er to at least the –min– marker.
Confirm OK.
O
pen and close the door to enable drying.
Information
Please open and close the
door
This it to remind you to load the laundry when the
S
team smoothing programme is selected.
L
oad the laundry in the drum.
To Next Page
Loading...
Need help?
General
