Settings menu
96
Display brightness
The brightness of the display can be
alt
ered.
The setting selected is shown in a bar
chart.
Factory default: a medium setting.
– Dimmer
– Brighter
You will see the brightness change as
the setting
is selected.
Display switch-off status
To save energy the display and sen‐
sors will go
out after 10 minutes and
the
Start/Stop sensor will flash slo
wly.
You can alter this setting.
Options
– On
T
he display will go out (after 10 mi‐
nutes):
– if a programme is not selected af‐
t
er the dryer has been switched on
– during the current programme
– after the end of a programme.
– On (not in current prog.)
(Factory de‐
fault setting)
The display will go out (as described
above) but will remain on while the
programme is running.
– Off
T
he display will remain on (i.e. it will
never go out).
You can switch the display back on by
t
ouching any sensor.
Appliance switch-off status
To save energy the dryer will switch
o
ff automatically after 15 minutes. You
can lengthen or shorten the time.
The dryer will switch off automatically
aft
er 10, 15 or 20 minutes,
– if no further selection is made after
switchi
ng the dryer on
– at the end of the anti-crease phase
– after a programme without an anti-
cr
ease phase has finished.
However, there is no automatic switch-
off in the event of a fault.
Options
– After 10 minutes
– After 15 minutes (F
actory default set‐
ting)
– After 20 minutes
Display maximum load
After a programme is selected the
maximum load appears in the display
for a shor
t time. You can switch this
off.
Options
– Yes (
Factory default setting)
– No
To Next Page
Loading...
