Installation and connection
84
T
urn the door lock through 180°.
P
ress the door lock into openings
on the opposite side of the door
opening.
Adjust the position of the door lock
so that the scr
ew holes line up with
those in the front panel of the dryer
.
Secur
e the door lock with the two
Torx screws.
3. Remove the lock catch from the
door
F
irst take the rubber seal off the door
and place this to one side.
Us
e a T20 Torx screwdriver to re‐
move screw on the lock catch.
P
ull off the lock catch together with
lock catch cover .
To Next Page
Loading...
Need help?
General
