Problem solving guide
68
General problems with the washing machine
Problem Possible cause and remedy
At the end of the pro‐
gramme there is still liq‐
uid in the capsule.
The small pipe in the detergent dispenser drawer onto
which the capsule is placed is blocked.
Clean the small pipe.
This is not a fault.
For technical reasons, a small amount of water will
remain in the capsule.
There is water next to
the capsule in the fabric
softener compartment.
The Cap sensor was not activated or an empty
capsule was not removed at the end of the last pro‐
gramme.
Make sure that you remember to activate the Cap
sensor the next time you insert a capsule.
Remove and then dispose of the empty capsule at
the end of each programme.
The small pipe in the detergent dispenser drawer onto
which the capsule is placed is blocked.
Clean the small pipe.
The display is in a dif‐
ferent language.
A different language has been selected in "Settings /
Language ".
Set the language you want. The flag symbol will
guide you.
The display is dark. The display has switched off automatically to save
energy (Standby mode).
Press any button. Standby comes to an end.
To Next Page
Loading...
