Problem solving guide
73
Fault message at the end of a programme
Problem Cause and remedy
Check dosage
Excessive foam has built up during washing.
Check the amount of detergent dispensed.
With automatic detergent dispensing, check the
dosage amount set.
Observe the instructions on the detergent pack-
aging and the degree of soiling of the laundry.
If necessary, reduce the dispensing quantity by in-
crements of 10%.
Hygiene info: Select
“Maintenance” and
run the “Clean ma-
chine” programme.
A wash programme using a temperature above 60°C
has not been run for a long time.
In order to prevent bacteria and unpleasant odours
building up in the washing machine, run the Clean
machine programme using Miele machine cleaner
or a universal powder detergent.
The messages will appear at the end of the programme and when the washing ma-
chine is switched on and need to be confirmed with the OK sensor.
To Next Page
Loading...
