Duty cycle 100% at 20°C 160A 180A 115A (140A)* 230A
150A (180A)*
Duty cycle 40% at 20°C 180A 220A 150A (175A)* 245A
180A (200A)*
Duty cycle 100% at 40°C 115A 145A 70A (88A)* 175A
107A (135A)*
Duty cycle 60% at 40°C 125A 170A 86A (108A)* 195A
130A (170A)*
Duty cycle max. at 40°C 25% 30% 14% (16%)* 25%
18% (25%)*
Open circuit voltage 45V 52V 52V 52V
52V
2
Sphere of application
3
Protection class IP 23S
4
IP 23 IP 23 IP 23
IP 23
Norm
EN/IEC60974-1
EN/IEC60974-5
EN/IEC60974-10 (Class A)
Dimensions (hxwxl) 66x38x79 cm 55x25x64 cm
96x57x87 cm (DUO)
55x25x64 cm
96x57x87 cm (DUO)
55x25x64 cm
96x57x87 cm (DUO)
55x25x64 cm
96x57x87 cm (DUO)
Weight 26,2 kg 25 kg
54 kg (DUO)
27 kg
56 kg (DUO)
26 kg
55 kg (DUO)
28 kg
57 kg (DUO)
* Data for Boost-version are stated at 1x230V mains supply
Data in parenthesis are stated at 3x400V mains supply
**= Power save function. The machine will enter the power save function 7.5 minutes after finalising the welding operation
WARRANTY REGULATIONS
Migatronic welding machines are quality-tested continuously throughout the production process and undergo a
thorough, quality-assured final function test as assembled units.
The warranty period is 12 months for new welding machines if no registration is carried out. Upon registration of new
welding machines within 6 weeks from invoicing, the warranty period is extended to 24 months.
Registration must be made on the online address: www.migatronic.com/warranty. The certificate of registry is proof
of the registration and will be sent by e-mail. The original invoice and the certificate of registry will document to the
buyer that the welding machine falls within the scope of a 24 months warranty period.
If registration is not made, the standard warranty period is twelve months for new welding machines, as from the date
of invoicing to end user. The original invoice is documentation for the warranty period.
Migatronic provides warranty according to the warranty conditions in force through remedying defects in the welding
machines that can be proved to be caused by improper materials or workmanship in the warranty period.
As a main rule, warranty is not provided for welding hoses as they are considered to be wear parts; defects that occur
within 6 weeks after putting into operation and which are caused by improper materials or workmanship will, however,
be considered warranty claims.
All forms of transport in connection with a warranty claim fall outside the scope of Migatronic’s warranty and will take
place for buyer’s own account and risk.
We refer to Migatronic’s warranty conditions at
www.migatronic.com/warranty
1
This equipment complies with IEC 61000-3-12 provided that the short-circuit power Ssc of the grid at the interface point is greater than or equal to the stated data
in the abovementioned table. It is the responsibility of the installer or user of the equipment to ensure, by consultation with the distribution network operator if
necessary, that the equipment is connected only to a supply with a short-circuit power Ssc greater than or equal to the stated data in the abovementioned table.
2
To Next Page
Loading...
Need help?
General
