Migomag SIM 200 LCD - Service, Maintenance, Transportation and Storage; Warning Label; Warranty

Migomag SIM 200 LCD
Model No ASIM200LCD
38
Service, Maintenance, Transportaon and Storage
The welder needs regular maintenance as following: Periodically clean dust, dirt, grease,
etc. from your welder. Every six months, or as necessary, remove the cover panel from
the welder and air-blow any dust and dirt that may have accumulated inside the welder.
Replace power cord, ground cable, ground clamp, or electrode assembly when damaged
or worn.
Minor and Roune Maintenance
Store in a clean dry facility free from corrosive gas, excess dust and high humidity.
Temperature range from 10F120°F and the relave humidity not more than 90%.
When transporng or storing the welder aer use, it is recommended to repack the
product as it was received for protecon. Cleaning is required before storage and you
must seal the plasc bag in the box for storage.
Warning Label
Warranty
Power Source Warranty
Period
Labour
Power source only
3 Years 2 Years
Accessories Warranty
Period
MIG & TIG torch, electrode holder lead, earth lead, gas hose, regulator
and any other accessories
6 Months
MIG & TIG torch consumable items
NIL