Migomag SIM 200 LCD - Page 5

Migomag SIM 200 LCD
Model No ASIM200LCD
2
• Follow the instrucons in this manual
• Keep welder in the o posion when not in use
• Connect ground lead as close to the area being welded as possible to ensure a good
ground
• Do not allow any body part to come in contact with the welding wire if you are in
contact with the material being welded, ground or electrode from another welder
• Do not weld if you are in an awkward posion. Always have a secure stance while
welding to prevent accidents. Wear a safety harness if working above ground
• Do not drape cables over or around your body
• Wear a full coverage helmet with appropriate shade (see ANSI Z87.1 safety standard)
and safety glasses while welding
• Wear proper gloves and protecve clothing to prevent your skin from being exposed to
hot metals, UV and IR rays
• Do not overuse or overheat your welder. Allow proper cooling me between duty
cycles
• Keep hands and ngers away from moving parts and stay away from the drive rolls
• Do not point torch at any body part of yourself or anyone else
• Always use this welder in the rated duty cycle to prevent excessive heat and failure
4. Specic Areas of Danger, Cauon or Warning
Electrical Shock
WARNING! Electric arc welders can produce a shock that can cause injury or death.
Touching electrically live parts can cause fatal shocks and severe burns. While welding, all
metal components connected to the wire are electrically hot. Poor ground connecons
are a hazard, so secure the ground lead before welding.
• Wear dry protecve apparel: coat, shirt, gloves and insulated footwear
• Insulate yourself from the work piece. Avoid contacng the work piece or ground
• Do not aempt to repair or maintain the welder while the power is on
• Inspect all cables and cords for any exposed wire and replace immediately if found