Table 4-4-2 Description of the buttons
60HZ flicker for NTSC mode and 50HZ flicker for PAL mode
There are several parameters such as Exposure Level, Maximum Exposure Time
and IR-CUT Interval, etc, associated with this mode.
Night Mode: Show in live view based on Night Mode settings
Day Mode: Show in live view based on Day Mode settings
Auto Mode: Show in live view based on environment, set the sensitivity for
switching Day Mode to Night Mode, or Night Mode to Day Mode
Customize: Show in live view based on your own settings’ time to start/end Night
Mode
This is the sensitivity for switching Day Mode to Night Mode. When IR Light
Sensor Current Value is lower than this value, it will switch Day Mode to Night
Mode.
This is the sensitivity for switching Night Mode to Day Mode. When IR Light
Sensor Current Value is higher than this value, it will switch Night Mode to Day
Mode.
The current value of the IR light sensor
With the combination of the High Beam and Low Beam, The IR LEDs technology
has been upgraded to provide better image clarity and quality regardless of the
object distance.
Customize mode is available.
The current value of Low-Beams LED and High-Beams LED light value
Adjust the light strength of Low-Beams LED light level from 0 to 100.
Adjust the light strength of High-Beams LED light level from 0 to 100.
Select indoor or outdoor mode to meet your needs.
There are three options available, you can select one to meet your need
Off: Keep the image in normal direction
Clockwise 90°: Rotate the image by 90° clockwise
Anticlockwise 90°: Rotate the image by 90° anticlockwise
There are four options available, you can select one to meet your need
Off: Keep the image in normal direction
Rotating 180°: Upside down the image
Flip Horizontal: Flip the image horizontally
Flip vertical: Flip the image vertically
To Next Page
Loading...
