Security Service
Table 4-5-10 Description of the buttons
Secure Shell (SSH) has many functions: it can replace Telnet and also provides a
secure channel for FTP, POP, even for PPP.
4.5.4 SIP
The Session Initiation Protocol(SIP) is a signaling communications protocol, widely used for
controlling multimedia communication sessions such as voice and video calls over Internet
Protocol(IP) networks. This page allows user to configure SIP related parameters. Milesight cameras
can be configured as SIP endpoint to call out when alarm triggered; or allow permitted number to
call in to check the video if the video IP phone is used. To use this function, the settings in SIP page
must be configured properly. There are two ways to get video through SIP, one is to dial the IP
address directly, the other is account registration mode. the details are as follows:
Method 1: IP Direct mode
Dial on the camera’s IP address directly through SIP phone, so you can see the video.
Note:
SIP phone and the camera should in the same network segment.
Method2: Account registration mode
1) Before using the SIP, you need to register an account for the camera from the SIP server;
2) Register another user account for the SIP device from the same SIP server;
3) Call the camera User ID from the SIP device, you will get the video on the SIP device.
SIP Settings
To Next Page
Loading...
