rtsp://IP:RTSP Port/third
rtsp://IP:RTSP Port/fourth
rtsp://IP:RTSP Port/fifth
Note:
1) Get the format of RTSP URL by clicking “ ”on the right side of RTSP Port.
2) DSCP refers to the Differentiated Service Code Point; and the DSCP value is used in the IP
header to indicate the priority of the data.
3) A reboot is required for the settings to take effect.
UPnP
Universal Plug and Play (UPnP) is a networking architecture that provides compatibility among
networking equipment, software and other hardware devices. The UPnP protocol allows devices to
connect seamlessly and to simplify the implementation of networks in the home and corporate
environments. With the function enabled, you don’t need to configure the port mapping for each
port, and the camera is connected to the Wide Area Network via the router.
Table 4-4-12 Description of the buttons
Check the checkbox to enable the UPnP function
Check the checkbox to enable the Port Mapping
The name of the device detected online can be edited
Auto: Automatically obtain the corresponding HTTP and RTSP port, without any
settings
Manual: Need to manually set the appropriate HTTP port and RTSP Port. When
To Next Page
Loading...
