Milesight Technology MS-C5374-PB - Page 57

51
1) The obtained IP address is dynamically assigned via PPPoE, so the IP address always changes
after rebooting the camera. To solve the inconvenience of the dynamic IP, you need to get a
domain name from the DDNS provider (e.g. DynDns.com).
2) The user name and password should be assigned by your ISP.
SNMP
You can set the SNMP function to get camera status, parameters and alarm related information and
manage the camera remotely when it is connected to the network.
Before setting the SNMP, please download the SNMP software and manage to receive the camera
information via SNMP port. By setting the Trap Address, the camera can send the alarm event and
exception messages to the surveillance center.
Table 4-4-16 Description of the buttons
Parameters
Function Introduction
SNMP v1/2/3
The version of SNMP, please select the version of your SNMP software.
SNMP v1: Provide no security
SNMP v2: Require password for access
SNMP v3: Provide encryption and the HTTPS protocol must be enabled
Write Community
Input the name of Write Community
Read Community
Input the name of Read Community
Trap Address
Set the trap address
Trap Port
Set the trap port, the default is 162
Trap Community Name
Input the trap community name