4. Installation
Standard Version:
1. Remove the backplate on the back of the device, screw the wall plugs into the wall and fix the
backplate with screws on it, then install back the device. Note that the vent of device should not
face upwards when installing.
2. Fix the bottom of the device to the cover with a fixing screw.
Magnetic Version:
Attached the device to a magnetic surface such as the metal surface of the refrigerator, freezer, freight
container, etc. The back of the device is equipped with anti-slip pad to secure firm and sturdy installation.
Note that the vent should not face upwards.
To Next Page
Loading...
