Milesight UF51 - Wired Access

15
E. After you login the Web GUI, you can view system information and perform configuration on the
device.
5.2 Wired Access
Connect PC to LAN port of UF51 directly. The following steps are based on Windows 10 operating
system for your reference.
A. Go to “Control Panel” → “Network and Internet” → “Network and Sharing Center”, then click “Ethernet”
(May have different names).
B. Go to “Properties” → “Internet Protocol Version 4(TCP/IPv4) ”, select “Obtain an IP address
automatically” or “Use the following IP address”, then assign a static IP manually within the same subnet
of the device.