Why wire remains energized after trigger is released on Miller Electric SuitCase X-TREME 12VS?
If the wire remains energized after the trigger is released, check contactor W1 to see if the contacts are frozen closed.
What to do if the display on Miller Electric SuitCase X-TREME 12VS doesn't light up?
If the display on the display board does not light, have a Factory Authorized Service Agent check Control board PC1, or replace the display board.
What to do if Miller Electric Welding System does not switch out of Soft Start?
If the unit does not switch out of Soft Start, check the transducer HD1 and its connections, and replace it if necessary.
What causes wire stubbing on low end in Miller Electric SuitCase X-TREME 12VS Welding System?
If wire stubbing occurs on the low end when using a constant current power source, ensure the CC/CV switch is in the CC position. If available, increase the power source inductance setting. You can also increase the output setting of the power source or decrease the wire feed speed.
Why is the motor running slowly on my Miller Electric SuitCase X-TREME 12VS Welding System?
If the motor runs slowly, check and replace the contact tip or liner if necessary. Have a Factory Authorized Service Agent check the Control board PC1. Note that if soft start is not on, the motor will switch to a slower speed if current is not sensed by HD1. When soft start is enabled, the motor will run slow until weld current is sensed by HD1.
What to do if wire feeds with Jog switch but not with gun trigger on Miller Electric SuitCase X-TREME 12VS?
If the wire feeds when the Jog switch is pressed but not when the gun trigger is pressed, check the gun trigger connection at the wire feeder. Also, check the gun trigger leads and trigger switch, referring to the gun Owner’s Manual. If the problem continues, have a Factory Authorized Service Agent check the Control board PC1.
What to do if gas does not flow or stop flowing in Miller Electric SuitCase X-TREME 12VS?
If the gas does not flow or does not stop flowing while the wire feeds, you can try the following: Check the gas valve and the coil voltage and connections of gas valve GS1, and check the continuity of the coil, replacing GS1 if necessary. Clear any blockage in the gas hose or replace the hose. Also, clear any blockage in the welding gun. If the issue persists, have a Factory Authorized Service Agent check the Control board PC1.
Why is software and weld time information on meter board PC20 not accurate Miller Electric SuitCase X-TREME 12VS?
General| TIG Lift Arc Start | Yes |
|---|---|
| Wire Feed Speed Range | 50 - 700 IPM (1.3 - 17.8 m/min) |
| Input Frequency | 60 Hz |
| Welding Processes | MIG, Flux-Cored, Stick |
| Stick Electrode Size Range | 1/16 - 1/8 in |
| Wire Size | 0.030 - 0.045 in (0.8 - 1.2 mm) |
| TIG Electrode Size Range | 1/16 - 3/32 in |
Details potential dangers associated with arc welding.
Details potential dangers associated with arc welding.
Provides technical specifications for the unit.
Details wire compatibility and feed speeds.
Illustrates how to connect equipment.
Details how to connect the gun and clamp.
Explains controls and meters on the unit.
Explains controls on units without meters.
Outlines regular maintenance tasks.
Common problems and their solutions.
Explains error indicators and diagnostic messages.
To Next Page