Miller 9700W - Page 57

51
PULSE ENABLE
Pulse Enable is either yes or no. If yes, them Pulsed is displayed
in the main screen.
TACHOMETER
Tachometer is either Yes or No. If yes, then the a tachometer for
the speed of the motor is attached to the 9700W
EXT START
Ext Start is either Maintain or None. If yes, then the 9700W will
accept an external start signal.
EXT JOG
Ext Jog is either None, Normal or Switch. If set to none the
external jog input are not used. If set to Normal they cause a wire
jog. If Switch then the left and right external jog inputs are
switched.
AUX1 NAME
By pressing the right arrow you will be able to enter the name for
the AUX1 output. This is the name that will be shown in the name
menu and on the run screen. The name is limited to 4
alpha/numeric characters.
CONFIG
YES
YES
YES
RAMP ENABLE
PULSE ENABLE
TACHOMETER
CONFIG
YES
YES
MAINTAIN
PULSE ENABLE
TACHOMETER
EXT START
CONFIG
YES
MAINTAIN
NONE
TACHOMETER
EXT START
EXT JOG
CONFIG
MAINTAIN
NONE
llu
EXT START
EXT JOG
AUX1 NAME
CONFIG
NONE
llu
llu
EXT JOG
AUX1 NAME
AUX2 NAME