52
AUX2 NAME
By pressing the right arrow you will be able to enter the name for
the AUX2 output. This is the name that will be shown in the name
menu and on the run screen. The name is limited to 4
alpha/numeric characters.
AUX3 NAME
By pressing the right arrow you will be able to enter the name for
the AUX3 output. This is the name that will be shown in the name
menu and on the run screen. The name is limited to 4
alpha/numeric characters.
PASSWORD, CONFIGURATION SUB MENU
Pressing the right button allows that user to see and change the
password for the configuration sub menu. If the password is set
to all blanks, then you do not need a password to get into the sub
menu.
MILLER WELDING AUTOMATION JOB NUMBER
Pressing the right button will show you the Miller Welding
Automation Job Number that this control unit shipped out on.
When the job number is displayed you can press either the left or
right arrow key to get out.
FIRMWARE VERSION
Shows the version number of the firmware in your unit.
To Next Page
Loading...