Name: Millipore direct-q 8 UV-R
Brand: Millipore
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Installation

Hydrating the System

• At this time, the Final Filter is not installed. Leave the system

overnight or for several hours in FILLING TANK mode or PRE

OPERATE mode (see

Section Operating Modes

). The system will

regularly recirculate water and rinse off purification media inside

the SmartPak cartridge. Do not leave the system in STANDBY mode.

• (The next morning) Press the Dispensing Button once to put the

system into DISPENSING mode.

• Allow about 1 Litre of water to be dispensed from the system.

• Press the Dispensing Button once again. The system will finish

dispensing water.

• Remove the Tygon Tubing and the Barbed Fitting from the POU

Dispenser.

• The Final Filter needs to be installed. See

Section Installation and

Rinsing of the Final Filter.

Questions and Answers:

Need help?

Do you have a question about the Millipore direct-q 8 UV-R and is the answer not in the manual?

Millipore direct-q 8 UV-R Specifications

General