Need help?Do you have a question about the Millipore Milli-Q Direct 8 System and is the answer not in the manual?
General| Brand | Millipore |
|---|---|
| Model | Milli-Q Direct 8 System |
| Category | Water Filtration Systems |
| Language | English |
Emphasizes proper installation and operation as per the manual.
Explains various hazard and information symbols used in the manual.
Details the characteristics of water delivered from a POD Unit.
Lists electrical specifications including voltage, frequency, fuse, and power usage.
Specifies the required parameters for feed water quality.
Explains that flow rate calibration is needed when the system is installed.
Explains how to enter the Manager Menu using Login and Password.
Instructions for changing the Login and Password for the Manager Menu.
Details various set points for controlling system messages and parameters.
Details various setup options including date, buzzer, recirculation, flow calibration, UV activation.
Details how to dispense water using the POD Unit plunger and flow settings.
Step-by-step guide for volumetrically dispensing water from the POD Unit.
Step-by-step guide to view system operation parameters.
Step-by-step guide to view system information.
Step-by-step instructions for removing the used Q-Pak Pack.
Step-by-step instructions for registering the installation of a POD Pak.
Step-by-step guide to open the Sanitisation Port.
Step-by-step guide for sanitising the RO Cartridge(s) using a chlorine tablet.
Step-by-step guide to clean the RO Cartridge(s) using a cleaning agent pouch.
Step-by-step instructions for cleaning the Inlet Strainer.
Conditions for calibrating the flow rate: new consumables, component change, inaccurate dispensing.
Advises not using the system during an alarm and contacting Millipore.
Step-by-step guide to view an alarm message on the Main Display.
Explains how to cancel alarm messages by fixing the cause or using the keypad.
To Next Page