Millipore Milli-Q Direct 8 System User Manual

Replacing the Q-Pak Pack
When
The Q-Pak Pack should be replaced when one of the following Alarm or Alert
essages is displayed.
 message = MILLI-Q RES < SP, REPLAC
 Alert me AK PACK
m
Alarm E Q-PAK
ssage = REPLACE Q-P
Removing
Remove the used Q-Pak Pack by following the steps below.
Step Action Diagram
1 Place the system into
STANDBY Mode.
2 Push the POD Plunger down
push down the
POD Plunger again.
once to depressurise the
System.
After water stops being
dispensed,
3 Open the System left door.
Lift up the Pack Locking
Handle.
Continued on next page
- 77 -

Millipore Milli-Q Direct 8 System Specifications

General

Brand	Millipore
Model	Milli-Q Direct 8 System
Category	Water Filtration Systems
Language	English